FS ProAc Studio 140 Mk 1

After ten years of pleasure from these speakers, I have decided to have a change and these must now go. I’m the second owner of these and they are about thirteen years old in total. As you can see from the photographs there is some sun fading to the left-hand speaker The right -hand speaker has a small dent (10mm)about three quarters of the way up it’s left-hand side as you look at it and some minor damage to the top rear edge. They are in full working order and I am happy to demonstrate them. The Studio 140s are quite sensitive; I have been running them very successfully on 7 wpc 300b valve amplification and never found volume to be wanting.

The following information is from the ProAc catalogue :-

Dimensions

Height on plinth with spiked feet 1040mm

Depth 280mm

Width 190mm

Weight 20 kg each with spikes and plinths

Tweeter ProAc 25mm coated silk dome with special coating and inner damping

Bass Driver (Two) 165mm ProAc unit with coated cone, raised spider assembly for greater linearity and large shielded magnet assembly

Grille Acoustically transparent crimplene

Recommended Amplifiers 15-250 watts

Frequency Response 25 Hz - 30 Khz

Nominal impedance – 8 ohms

Sensitivity Nominal Impedance 91db linear for 1watt at 1 metre 4 Ohms

Whilst I have the original boxes (see photo below), this sale is very strictly collection only from Linslade, Bedfordshiŕe.

Looking for £375.00 o.v.n.o.![proac%2001|299x500]

Sold stp etc etc